6. Tutorials ✍️

• 6.1. Geometry Modeling and Preparation for Automated Meshing: An Example of the ONERA M6 Wing
  • 3D Sketches of Airfoils
  • Wing Planform
  • Wing Solid Model
  • Adding Edge Attribute
  • Adding Face and Group Attributes
• 6.2. RANS CFD on 2D High-Lift System Configuration Using the Flow360 Python API
  • Modeling Multi-element Configurations in ESP
  • RUN CFD on multi-element configurations using Flow360
• 6.3. Blade Element Theory using the XV-15 rotor and the Flow360 Python API
  • Preprocessing
  • Flow360 BET Configuration
  • Running the case
  • Output and postprocessing
• 6.4. Time-accurate RANS CFD on a propeller using a sliding interface: the XV-15 rotor geometry
  • Rotational and stationary volumes
  • Sliding interface requirements
  • XV-15 setup
  • Uploading your mesh
  • Defining a case using Flow360 Python API.
  • Case input conditions
  • Case running
• 6.5. Calculating Dynamic Derivatives using Sliding Interfaces
  • Geometry and Mesh
  • Case Setup
  • Postprocessing
• 6.6. Automated Meshing for Internal Flow
  • Geometry
  • Meshing
• 6.7. Conjugate Heat Transfer for Cooling Fins
  • Geometry and Mesh
  • Case
  • Results
• 6.8. TU Berlin TurboLab Stator simulation using periodic boundary conditions
  • Description
  • Meshing the geometry
  • Defining the boundary conditions.
  • Case running
  • Translational periodic boundary conditions
• 6.9. User Defined Dynamics
  • PI Controller for Angle of Attack to Control Lift Coefficient
  • Dynamic Grid Rotation using Structural Aerodynamic Load
  • Custom set of user defined forces and moments
• 6.10. User Defined Postprocessing via UserDefinedField
  • Custom Output Variable
  • Custom surface integral